Main Features
- It measures nozzle pressures up to 4000 bar and melting temperatures of 400°C.
- Multi-shot measurements are possible at various pressure levels and temperatures below 230°C.
- It can be easily installed with magnets, without the need for screws.
- Combine the IN sensor with the nozzle touch force sensor.
- Ideal for services and development.
(Measurements cannot be taken while the device is in operation.)
Multishot
To measure various pressures (up to 4000 bar), the IN tip can be heated with a heating band (maximum temperature 230°C).
In this way, the plastic injected into the dead volume remains in liquid form.
You can choose from steps of 500, 1000, 1500, and 2000 bar.
In this way, the plastic injected into the dead volume remains in liquid form.
You can choose from steps of 500, 1000, 1500, and 2000 bar.
single shot
Even when the resin temperature exceeds 230°C (up to 400°C), pressure can be measured in a single shot.
The solidified plastic remaining inside the sensor must be removed after each shot.
The solidified plastic remaining inside the sensor must be removed after each shot.
Magnetic attachment
Thanks to the magnetic base, installation is very quick and easy.
This allows a nozzle check to be attached to the mold.
This allows a nozzle check to be attached to the mold.
Technical data | |
Strain gauge type | Foil |
Measurement range | 4000bar |
maximum contact force | 300kN (for tie bars up to 60mm in diameter) |
sensitivity | 1.5 mV/V (nominal) |
Accuracy error | < ± 0.5% FS |
Linearity error | < 0.2% FS |
Reproducibility error | < 0.2% FS |
Operating temperature range | 10°...+230°C (Up to 400°C in single-shot applications) |
Storage Temperature Range | -20°C to +70°C |
Protection class | IP50K |
Case material | Stainless steel (high grade) |